Adtran 1000R Series Manuale Utente Scaricare il pdf (Pagina 19)

Command Reference Guide Basic Mode Command Set

ping <address>

Use the ping command (at the Basic Command mode prompt) to verify Internet Protocol (IP) network

connectivity.

Syntax Description

<address> Specifies the IP address of the system to ping. Entering the ping command with

no specified address prompts the user with parameters for a more detailed ping

configuration. Refer to Functional Notes (below) for more information.

Default Values

No default value necessary for this command.

Applicable Platforms

This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and

Total Access 900 Series units.

Command History

Release 1.1 Command was introduced.Command was introduced.

Functional Notes

The ping command helps diagnose basic IP network connectivity using the Packet InterNet Groper

program to repeatedly bounce Internet Control Message Protocol (ICMP) echo-request packets off a

system (using a specified IP address). The AOS allows executing a standard ping request to a specified IP

address or provides a set of prompts to configure a more specific ping configuration.

The following is a list of output messages from the ping command:

! Success

- Destination Host Unreachable

$ Invalid Host Address

X TTL Expired in Transit

? Unknown Host

* Request Timed Out

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 136 137

Nessun commento

Adtran 1000R Series Manuale Utente Pagina 19