ADTRAN BlueSecure Controller Guida di Installazione Scaricare il pdf (Pagina 6)

BlueSecure™ Access Point 1800 Installation Guide

Table 1: Status and Radio LED Definitions

Status 2.4Ghz LED 5Ghz LED Description

Yellow Solid Off Off Initial power-up

Green Solid Off Off Initializing software and acquiring an IP

address

Green Blink Off Off Discovering Bluesocket controller

Green Solid Green

Solid/Blink

Green

Solid/Blink

Radios Activated and passing traffic

Orange Solid Off Off Software Upgrade

Table 2: Network LED Definitions

Network LED Description

Off No Link Detected

Amber - ON 10/100 Link Detect with No Activity

Amber - Blinking 10/100 Link Detect with with Activity

Green - ON 1000 Link Detect with No Activity

Green - Blinking 1000 Link Detect with with Activity

The BSAP does not have a power switch. It’s powered on when connected to a Power over

Ethernet (PoE) from a PoE injector (BSAP-POE-001-00-0), switch or other network device that

supplies power over the network cable based on the IEEE 802.3af standard.

Ethernet/PoE Connector

The BSAP-1800 has one auto-sensing 10BASE-T/100BASE-TX/1000BaseT RJ-45 connector that

can be attached directly to 10BASE-T/100BASE-TX/1000BaseT switches to provide a full-duplex

link. These segments must conform to the IEEE 802.3 or 802.3u specifications.

This connector uses an MDI (i.e., internal straight-through) pin configuration. You can use

straight-through twisted-pair cable to connect this port to most network interconnection devices

1 2 3 4 5 6 7 8 9 10 11 ... 24 25

Nessun commento

ADTRAN BlueSecure Controller Guida di Installazione Pagina 6