ADTRAN Tracer TRACER 2 x E1 Manuale Utente

Navigare online o scaricare Manuale Utente per Networking ADTRAN Tracer TRACER 2 x E1. ADTRAN Tracer TRACER 2 x E1 User`s manual Manuale Utente

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa

Sommario

Pagina 1 - User’s Manual

TRACER 2 x E1 User’s Manual, 2001 61280004L2-1CTRACER® 2 x E1User’s Manual

Pagina 2 - 61280004L2-1C

TRACER 2 x E1 User’s Manual61280004L2-1CTable of Contentsviii

Pagina 3 - TRACER 2 x E1 User’s Manual i

INTRODUCTIONThe Dual E1 version of TRACER provides two, individual E1 transports via a 2.4 GHz or 5.8 GHz,direct sequence, spread spectrum microwave l

Pagina 4 - TRACER 2 x E1 User’s Manual

TRACER 2 x E1 User’s Manual61280004L2-1CSection 1 TRACER Description2Direct SequenceA direct sequence transmitter spreads the signal by mixing the da

Pagina 5

TRACER 2 X E1 User’s Manual61280004L2-1CSection 1 TRACER Description3E1 InterfacesThe E1 interfaces conform to the ITU G.703 and G.704 electrical and

Pagina 6

TRACER 2 x E1 User’s Manual61280004L2-1CSection 1 TRACER Description4A block diagram of the BBP is shown in Figure 1-5.VT100 RS-232 InterfaceAn RS-23

Pagina 7

TRACER 2 X E1 User’s Manual61280004L2-1CSection 1 TRACER Description5• Loss of signal• Code violation• CRC error• Framing error• Remote alarm•

Pagina 8

TRACER 2 x E1 User’s Manual61280004L2-1CSection 1 TRACER Description6As a rule, a green LED indicates a normal situation, a red LED indicates an erro

Pagina 9

TRACER 2 X E1 User’s Manual61280004L2-1CSection 1 TRACER Description7The LEDs that indicate error conditions in the spread spectrum data pump and RFC

Pagina 10 - Table of Contents

TRACER 2 x E1 User’s Manual61280004L2-1CSection 1 TRACER Description8Built-In TestsThe TRACER has several features to aid in site setup and later deb

Pagina 11 - TRACER DESCRIPTION

TRACER 2 X E1 User’s Manual61280004L2-1CSection 1 TRACER Description9Three SMA connectors, located on the RFC module, provide RF and IF connection po

Pagina 12 - Section 1 TRACER Description

TRACER 2 x E1 User’s Manual, 200161280004L2-1C

Pagina 13

TRACER 2 x E1 User’s Manual61280004L2-1CSection 1 TRACER Description10Figure 1-11. Mastmount RFC HousingUp Angle ViewEye Level ViewWARNINGMounting C

Pagina 14

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation11UNPACK, INSPECTCarefully inspect the TRACER for any shipping damages. If damage is s

Pagina 15

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation12GroundingThe following grounding instructions are derived from the Underwriters’ Labo

Pagina 16

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation13E1 InterfacesThe E1 interface conforms to the ITU G.703 and G.704 electrical and sign

Pagina 17

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation14Three loopback functions are provided for diagnostic capability of each E1 interface.

Pagina 18 - RSSI GND TX PWR

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation15Antenna Feedline LossFeedline loss is a function of feedline type and length. Feedli

Pagina 19 - IF ANTENNA

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation16Path LossThe free space path loss is given byLoss(dB) = 96.6 + 20 log10 f + 20log10D

Pagina 20

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation17The nominal received signal level is -60 dBm. For help in link planning, use the pat

Pagina 21 - INSTALLATION

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation18SETTING THE RFC FREQUENCY PLAN ON NON 1 WATT 2.4 GHZ MODELSThe frequency plan designa

Pagina 22 - Section 2 Installation

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation199. Reattach the cable assemblies from the ports labelled “Tx” and “Rx” on the RFC and

Pagina 23

This equipment has been tested and found to comply with the limits for an intentional radiator, pursuantto Part 15, Subpart C of the FCC Rules. This

Pagina 24 - RF Link21 3

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation20SETTING THE RFC FREQUENCY PLAN ON 5.8 GHZ MODELSThe 5.8 GHz RFC operates on Plan A, T

Pagina 25

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation21CONNECTING THE BBP AND THE RFCThe BBP and the RFC are connected by an IF cable, eithe

Pagina 26

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation22CO-LOCATING MULTIPLE SYSTEMSWhen multiple transmitters are to be co-located (installe

Pagina 27

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation23REMOTE BERTThe TRACER includes a Bit Error Rate Tester (BERT) to verify that the inst

Pagina 28

TRACER 2 x E1 User’s Manual61280004L2-1CSection 2 Installation24

Pagina 29

VT100 USER INTERFACEThe TRACER may be accessed with a VT100 compatible terminal set to 9600 bits per second, 8 databits, and no parity, connected to

Pagina 30

TRACER 2 x E1 User’s Manual61280004L2-1CSection 3 Operation26MAIN MENU SELECTIONSSystem Status ScreenThe screen in Figure 3-1 displays the status of

Pagina 31

TRACER 2 x E1 User’s Manual61280004L2-1CSection 3 Operation27Main Menu ScreenPressing “M” on any screen will take the user to the Main Menu (see Figu

Pagina 32

TRACER 2 x E1 User’s Manual61280004L2-1CSection 3 Operation28E1 Status / Configuration / LoopbackThe status of the two E1 interfaces is displayed on

Pagina 33

TRACER 2 x E1 User’s Manual61280004L2-1CSection 3 Operation29Link Performance HistoryThe screen in Figure 3-6 presents detailed error statistics for

Pagina 34

TRACER 2 x E1 User’s Manual61280004L2-1CRadio Frequency Interference Statementii• The installed antenna must not be located in a manner that allows ex

Pagina 35 - OPERATION

TRACER 2 x E1 User’s Manual61280004L2-1CSection 3 Operation30E1A Statistics PageThe screen in Figure 3-7 presents detailed error statistics for E1A.

Pagina 36 - Section 3 Operation

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting31GENERALIf you experience a problem with the TRACER system, check to ensure that al

Pagina 37

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting32Recommended Actions:1. Check the RX power using the VT100 user interface or RSSI v

Pagina 38

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting33“LBK-A” or “LBK-B” is LitThis indicator will activate when a software or front pan

Pagina 39

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting34ALM is LitWhen the ALM light is on (solid), it indicates reception of an UA1 sign

Pagina 40

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting35“Test” Light is Lit or BlinkingThe test alarm will remain on (solid) during power-

Pagina 41 - TROUBLESHOOTING

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting36I M P O R T A N TIf problems persist after you have followed the Recommended Actio

Pagina 42 - Section 4 Troubleshooting

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting37I M P O R T A N TIf problems persist after you have followed the Recommended Actio

Pagina 43

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting38OOF AlarmThe OOF alarm is indicated on the E1A or E1B Status/Configuration/Loopbac

Pagina 44

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting39Recommended Actions:1. Check the far-end equipment for alarms or a LOS condition.2

Pagina 45

TRACER 2 x E1 User’s Manual61280004L2-1CTable of ContentsiiiPageSection 1. Tracer DescriptionIntroduction ...

Pagina 46

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting40Code Sync StatusThe Code Sync Status will indicate NO on the TRACER System Status

Pagina 47

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting41Carrier Sync Status or E1 Mux Sync StatusThe Carrier Sync status will indicate NO

Pagina 48

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting42RFC Link Up StatusThe RF Link Up Status will indicate NO on the TRACER System Stat

Pagina 49

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting43SES Values in E1A or E1B Performance History MenuThis value indicates the number o

Pagina 50

TRACER 2 x E1 User’s Manual61280004L2-1CSection 4 Troubleshooting44

Pagina 51

This section lists the specifications for the TRACER system.TransmitterOutput Power100 mW Transmitter ... +20 dBm, maximum1 W Trans

Pagina 52

TRACER 2 x E1 User’s Manual61280004L2-1CSection 5 Specifications46Test Points ... RSSI, QPSK ConstellationVT

Pagina 53

WARRANTYADTRAN will replace or repair this product within five years from the date of shipment if it does notmeet its published specifications or fail

Pagina 54

TRACER 2 x E1 User’s Manual61280004L2-1CSection 6 Warranty, Ordering and Return Information48

Pagina 55 - SPECIFICATIONS

ACRONYMS USED IN THIS MANUALAMI ... Alternate Mark InversionBER ...

Pagina 56 - Section 5 Specifications

TRACER 2 x E1 User’s Manual61280004L2-1CTable of ContentsivE1 Interfaces ...

Pagina 57 - WARRANTY, ORDERING AND RETURN

TRACER 2 x E1 User’s Manual61280004L2-1CGlossary50

Pagina 58

The cable connections required for various configurations are detailed below.Terminal Connection (DB-25)Tracer (DCE) Terminal (DTE)Number Name Number

Pagina 59 - GLOSSARY

TRACER 2 x E1 User’s Manual61280004L2-1CAppendix A Cable ConnectionsA-2

Pagina 60 - Glossary

TRACER 2 x E1 User’s Manual61280004L2-1CTable of ContentsvMain Menu Screen...

Pagina 61 - CABLE CONNECTIONS

TRACER 2 x E1 User’s Manual61280004L2-1CTable of ContentsviCarrier Sync Status or E1 Mux Sync Status ....

Pagina 62 - Appendix A Cable Connections

TRACER 2 x E1 User’s Manual61280004L2-1CTable of ContentsviiIllustrationsFigure 1-1. Typical Application............

Commenti su questo manuale

Nessun commento